2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)

3. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)

C109005E01
  1. Disengage the 6 claws and remove the shifting hole cover.


4. REMOVE CONSOLE BOX REAR COVER

C109006E01
  1. Disengage the 8 claws and remove the console box rear cover.


5. REMOVE CONSOLE BOX CARPET

C109008
  1. Remove the console box carpet.


6. REMOVE CONSOLE BOX ASSEMBLY REAR

C116873
  1. Remove the bolt and disengage the 2 clips to remove the console box.


7. REMOVE CENTER AIRBAG SENSOR ASSEMBLY

B106565E01

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. Pull the lever down and detach the connector holder.

  1. B106566
    Remove the 3 bolts and remove the airbag sensor.

← ON-VEHICLE INSPECTION (from Aug 2005)INSTALLATION (from Aug 2005) →