2005-2008 Yaris · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Jan 2006

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the LH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.


1. INSTALL FRONT AIRBAG SENSOR

B106583

NOTICE:
  1. Do not use a front airbag sensor that has been dropped.
  2. Do not subject the front airbag sensor any impact or force.

  1. Confirm that the ignition switch is turned to off.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    1. Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
    2. Do not start the operation for at least 90 seconds after disconnecting the negative battery terminal.

  1. Connect the airbag connector.

    1. Check that the CPA is in the provisionally locked condition.

    2. B106584E01
      Push the CPA until it makes a click sound.

      NOTICE:
      1. Engage the connector by pushing it straight.
      2. Hold the CPA when engaging the connector.
      3. Do not engage the CPA while pressing the CPA upper portion, otherwise, the half connection prevention mechanism will not function.

    3. Confirm that the rear side of the housing and the CPA rear surface are tightly fitted together.

  1. B106581E01
    Install the front airbag sensor with the 2 bolts.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

  1. Confirm that there is no looseness by shaking the front airbag sensor.


2. INSTALL FRONT BUMPER COVER

  1. B134823
    Install the 2 clips and the screw grommet.

  1. B134801
    w/ Fog Light:

    1. Connect the 2 fog light connectors.

    2. Engage the 6 claws and install the front bumper cover.

  1. B134800
    w/o Fog Light:

    1. Engage the 6 claws and install the front bumper cover.

  1. B134805
    Install the 6 clips.

  1. Install the 2 screw grommets.

  1. Tighten the 7 screws and 3 bolts.

  1. B134799E01
    Remove the protective tape.


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


4. INSPECT SRS WARNING LIGHT
(Click here)
← REMOVAL (from Jan 2006)COMPONENTS (from Aug 2005) →