2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Jan 2006

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT BUMPER COVER

  1. B134799E01
    Apply protective tape, as shown in the illustration.

  1. B134803
    Remove the 7 screws and 3 bolts.

  1. Remove the 2 screw grommets.

  1. Remove the 6 clips.

  1. B134801
    w/ Fog Light:

    1. Disengage the 6 claws and remove the front bumper cover.

    2. Disconnect the 2 fog light connectors.

  1. B134800
    w/o Fog Light:

    1. Disengage the 6 claws and remove the front bumper cover.

  1. B134823
    Remove the 2 clips and the screw grommet.


3. REMOVE FRONT AIRBAG SENSOR

B106581E01

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. Remove the 2 bolts.

  1. Disengage the 2 claws and remove the front airbag sensor.

  1. B106582E01
    Disconnect the airbag connector.

    NOTICE:
    1. Do not disconnect the airbag connector by pulling the wire harness.
    2. Release the lock without holding the upper side of CPA.


    1. While pushing the housing, slide only the CPA backward (from a provisionally locked state).

    2. Detach the connector while pushing the housing in the provisionally locked state.

      NOTICE:
      1. Do not disconnect the airbag connector by pulling the wire harness.
      2. Release the lock without holding the upper side of CPA.

    3. B106583
      After detaching the connector, confirm that the CPA protrudes beyond the rear of the housing.

← ON-VEHICLE INSPECTION (from Jan 2006)INSTALLATION (from Jan 2006) →