2005-2008 Yaris · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jan 2006


INSPECT FRONT WIPER MOTOR (for LHD)

E104082E01
  1. Check the LO operation.

    1. Connect the positive battery (+) lead to terminal 5 (+1) of the connector and the negative battery (-) lead to terminal 4 (E), then check that the motor operates at low speed (LO).

      Standard:
      Motor operates at low speed (LO).

      If the result is not as specified, replace the motor.

  1. Check the HI operation.

    1. Connect the positive battery (+) lead to terminal 3 (+2) of the connector and the negative battery (-) lead to terminal 4 (E), then check that the motor operates at high speed (HI).

      Standard:
      Motor operates at high speed (HI).

      If the result is not as specified, replace the motor.

  1. Check the automatic stop operation.

    1. Connect the positive battery (+) lead to terminal 5 (+1) of the connector and the negative battery (-) lead to terminal 4 (E). With the motor operating at low speed (LO), disconnect terminal 5 (+1) to stop the wiper motor operation in any position other than the automatic stop position.

    2. Using SST, connect terminals 1 (S) and 5 (+1). Connect the positive battery (+) lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

      SST
      09843-18040  

    3. E113864E03
      Check that the motor stops automatically in the automatic stop position.

      Standard:
      Refer to the illustration.

      If the result is not as specified, replace the motor assembly.


INSPECT FRONT WIPER MOTOR (for RHD)

E104082E04
  1. Check the LO operation.

    1. Connect the positive battery (+) lead to terminal 1 (+1) of the connector and the negative battery (-) lead to terminal 5 (E), then check that the motor operates at low speed (LO).

      Standard:
      Motor operates at low speed (LO).

      If the result is not as specified, replace the motor.

  1. Check the HI operation.

    1. Connect the positive battery (+) lead to terminal 4 (+2) of the connector and the negative battery (-) lead to terminal 5 (E), then check that the motor operates at high speed (HI).

      Standard:
      Motor operates at high speed (HI).

      If the result is not as specified, replace the motor.

  1. Check the automatic stop operation.

    1. Connect the positive battery (+) lead to terminal 1 (+1) of the connector and the negative battery (-) lead to terminal 5 (E). With the motor operating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation in any position other than the automatic stop position.

    2. Using SST, connect terminals 3 (S) and 1 (+1). Connect the positive battery (+) lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

      SST
      09843-18040  

    3. E113865E02
      Check that the motor stops automatically in the automatic stop position.

      Standard:
      Refer to the illustration.

      If the result is not as specified, replace the motor.

← REMOVAL (from Jan 2006)INSTALLATION (from Jan 2006) →