2005-2008 Yaris · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jan 2006


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT WIPER ARM HEAD CAP

  1. E127832E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 2 front wiper arm head caps.


3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

  1. E127833
    Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

  1. Remove the nut and front wiper arm.


4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


5. REMOVE COWL SIDE VENTILATOR SUB-ASSEMBLY LH

  1. E127834E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the cowl side ventilator sub-assembly LH.


6. REMOVE COWL SIDE VENTILATOR SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


7. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for RHD)

  1. E127835
    Disengage the 2 clips, the 6 claws and the 10 hooks.

  1. Remove the cowl top ventilator louver sub-assembly.

  1. E127836
    Disconnect the washer hoses.

  1. Disengage the 5 hooks.


8. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for LHD)

  1. E127838
    Disengage the 3 clips, the 4 claws and the 8 hooks.

  1. Remove the cowl top ventilator louver sub-assembly.

  1. E127839
    Disconnect the washer hoses.

  1. Disengage the 5 hooks.


9. REMOVE FRONT WIPER MOTOR AND LINK

  1. E127837
    Remove the 2 bolts.

  1. Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.


10. REMOVE FRONT WIPER MOTOR

  1. E113858E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the meshing of the rod at the crank arm pivot of the front wiper motor.

  1. E113859
    Remove the 3 bolts and the front wiper motor.

← ON-VEHICLE INSPECTION (from Jan 2006)INSPECTION (from Jan 2006) →