2005-2008 Yaris · Service Manual SECURITIES

Certification ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

This circuit provides power to operate the certification ECU.

WIRING DIAGRAM

B122855E02

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-B)

  1. B122728E01
    Remove the ECU-B fuse from the engine room R/B and J/B.

  1. Measure the resistance.

    Standard resistance:
    Below 1 Ω

  1. Reinstall the ECU-B fuse.



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY AND BODY GROUND)
B107456E23
  1. Disconnect the D60 certification ECU connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    D60-17 (E) - Body ground
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Specified Condition
    D60-1 (+B1) - Body ground
    11 to 14 V

  1. Reconnect the certification ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU


← ID Code Box Power Source Circuit (from Aug 2005)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2005) →