P0976 Shift Solenoid "B" Control Circuit Low (Shift Solenoid Valve S2)
Diagnostic trouble codes · Vehicles built from Aug 2005
Also covers:
- P0977 Shift Solenoid "B" Control Circuit High (Shift Solenoid Valve S2)
DESCRIPTION
Shifting from 1st to 4th is performed in combination with the ON and OFF operations of shift solenoid valves S1 and S2 which are controlled by the ECM. If an open or short circuit occurs in either of the shift solenoid valves, the ECM controls the remaining normal shift solenoid valve to allow the vehicle to be driven smoothly.(If an open or short circuit occurs, the ECM stops sending currents to the affected circuit.)
Fail-safe function (Click here).
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0976 |
ECM detects short in solenoid valve S2 circuit 4 times when solenoid valve S2 is operated. (1-trip detection logic) |
|
| P0977 |
ECM detects open in solenoid valve S2 circuit 4 times when solenoid valve S2 is not operated. (1-trip detection logic) |
|
MONITOR DESCRIPTION
The ECM commands gearshift by turning the shift solenoid valves "ON/OFF". When there is an open or short circuit in the shift solenoid valve S2 circuit, the ECM detects the problem and the MIL comes on. Illuminating the MIL, the ECM performs the fail-safe and turns the other functioning shift solenoid valve ON/OFF.(If an open or short circuit occurs, the ECM stops sending currents to the affected circuit.)
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Shift solenoid valve S2 is turned on/off normally when the shift lever is in the D position:
Gearshift controlled by ECM
1st
2nd
3rd
4th
Shift solenoid valve S2
ON
OFF
OFF
ON
| 1. INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE S2) |
![]() ![]() |
Disconnect the transmission wire connector from the transaxle.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
10 (S2) - Body ground
11 Ω to 15 Ω at 20°C (68°F)
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
![]() ![]() |
Connect the transmission connector to the transaxle.
Disconnect the ECM connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
78 (S2) - Body ground
11 Ω to 15 Ω at 20°C (68°F)
|
|
||||
| OK | ||
| ||
| 3. INSPECT SHIFT SOLENOID VALVE S2 |
![]() ![]() |
Remove shift solenoid valve S2.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
Solenoid Connector (S2) - Solenoid Body (S2)
11 to 15 Ω at 20°C (68°F)
Connect the positive (+) lead to the terminal of the solenoid connector and the negative (-) lead to the solenoid body to check the solenoid valve operation.
- OK:
- The solenoid makes operating sounds.
|
|
||||
| OK | ||
| ||



