2005-2008 Yaris · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Aug 2005


1. INSTALL FRONT DIFFERENTIAL CASE

G021409
  1. Install appropriate thrust washers and side gears.
    Refer to the table below and select thrust washers that bring the backlash to within the specifications. Select washers of the same size for both sides.

    Standard backlash:
    0.05 to 0.20 mm (0.0020 to 0.0079 in.)

    Thickness mm (in.)
    Thickness mm (in.)
    0.50 (0.0197)
    0.75 (0.0295)
    0.55 (0.0217)
    0.80 (0.0315)
    0.60 (0.0236)
    0.85 (0.0335)
    0.65 (0.0256)
    0.90 (0.0354)
    0.70 (0.0276)
    0.95 (0.0374)

  1. G021410
    Install the thrust washers and the side gears into the differential case.

  1. G021411
    Install the pinion shaft.

  1. G021412
    Using a dial indicator, check the side gear backlash.
    Measure the side gear backlash while holding one pinion gear toward the differential case.

    Standard backlash:
    0.05 to 0.20 mm (0.0020 to 0.0079 in.)

    If the backlash is not within the specifications, install a thrust washer of a different thickness.

  1. G021414
    Using a pin punch and a hammer, install the pinion shaft straight pin through the front differential case and the hole in the pinion shaft.

  1. G021556
    Using a hammer and chisel, caulk the pin holes around the circumference of the front differential case.


2. INSTALL FRONT DIFFERENTIAL RING GEAR

C058905E07
  1. Using a heater, heat the front differential ring gear to 90 to 110°C (194.0 to 230.0°F).

  1. Clean the contact surface of the front differential case.

  1. G021558E02
    Aligning the matchmarks, quickly install the front differential ring gear onto the front differential case with the 6 bolts.

    Torque:
    124 N*m{ 1,260 kgf*cm , 91 ft.*lbf }


3. INSTALL FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING

G021559E01
  1. Using SST and a press, install the front differential case rear tapered roller bearing.

    SST
    09350-32014   (09351-32120, 09351-32140)


4. INSTALL FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING

F100233E01
  1. Using SST and a press, install the front differential case front tapered roller bearing.

    SST
    09350-32014   (09351-32120, 09351-32140)

← DISASSEMBLY (from Aug 2005)COMPONENTS (from Aug 2005) →