2005-2008 Yaris · Service Manual ENGINE

B2272 Ignition 1 Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

This DTC is output when a malfunction occurs in the IG output circuit, which is between the IG1 relay actuation circuit inside the main body ECU and the IG1 relay.
DTC No.
DTC Detection Condition
Trouble Area
B2272
IG1 relay actuation circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  2. IG1 relay
  3. Wire harness

WIRING DIAGRAM

A122221E04

INSPECTION PROCEDURE


1. READ VALUE OF INTELLIGENT TESTER (IG1 RELAY MONITOR (INSIDE))
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body/ Main Body ECU/ Data List / IG1 Relay Mon2.

  1. Read the display on the tester.

    Main Body ECU:
    Item
    Measurement Item / Display (Range)
    Normal Condition
    IG1 Relay Mon2
    IG1 inner relay monitor / ON or OFF
    ON: Ignition switch on (IG)
    OFF: Ignition switch off

    OK:
    ON appears on the screen.



NG
Go to step 3
OK


2. CHECK SWITCH CONDITION (IGNITION SWITCH)
  1. Ensure the electrical key is inside the cabin.

  1. Check that the power source mode changes as shown below each time the ignition switch is.

OK:
off → on (ACC) → on (IG) → off



NG
GO TO POWER SOURCE MODE DOES NOT CHANGE
OK

NORMAL

3. INSPECT RELAY (IG1)

  1. A032779E02
    Remove the IG1 relay from the main body ECU.

  1. Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω (when battery voltage applied to terminals 1 and 2)

  1. Reinstall the relay.



NG
REPLACE IGNITION RELAY NO. 1
OK

REPLACE MAIN BODY ECU


← B2271 Ignition Hold Monitor Malfunction (from Aug 2005)B2273 Ignition 2 Monitor Malfunction (from Aug 2005) →