2005-2008 Yaris · Service Manual ENGINE

B2273 Ignition 2 Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

This DTC is output when a malfunction occurs in the IG output circuit, which is between the IG2 relay actuation circuit inside the main body ECU and the IG2 relay.
DTC No.
DTC Detection Condition
Trouble Area
B2273
IG2 relay actuation circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  1. IG2 relay
  1. Wire harness

WIRING DIAGRAM

A122223E01

INSPECTION PROCEDURE


1. READ VALUE OF INTELLIGENT TESTER (IG2 RELAY MONITOR (INSIDE))
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body/ Main Body ECU/ Data List / IG2 Relay Mon2.

  1. Read the display on the tester.

    Main Body ECU:
    Item
    Measurement Item / Display (Range)
    Normal Condition
    IG2 Relay Mon2
    IG2 inner relay monitor / ON or OFF
    ON: Ignition switch on (IG)
    OFF: Ignition switch off

    OK:
    ON appears on the screen.



NG
Go to step 3
OK


2. CHECK SWITCH CONDITION (IGNITION SWITCH)
  1. Ensure the electrical key is inside the cabin.

  1. Check that the power source mode changes as shown below each time the ignition switch is.

OK:
off → on (ACC) → on (IG) → off



NG
GO TO POWER SOURCE MODE DOES NOT CHANGE
OK

NORMAL

3. INSPECT INTEGRATION RELAY (IG2 RELAY)

  1. A122225E01
    Remove the integration relay from the engine room relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    1B-4 - 1C-1
    10 kΩ or higher
    1B-4 - 1C-1
    Below 1 Ω
    (when battery voltage is applied to terminals 1B-2 and 1B-3)

  1. Reinstall the integration relay.



NG
REPLACE INTEGRATION RELAY
OK


4. CHECK HARNESS AND CONNECTOR (INTEGRATION RELAY - MAIN BODY ECU)

  1. A122224E01
    Remove the integration relay from the engine room relay block.

  1. Disconnect the D65 main body ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    1B-2 (Integration relay) - D65-5 (IG2D)
    Below 1 Ω
    1B-3 (Integration relay) - Body ground
    Below 1 Ω
    1B-2 (Integration relay) or D65-5 (IG2D) - Body ground
    10 kΩ or higher

  1. Reinstall the integration relay.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← B2272 Ignition 1 Monitor Malfunction (from Aug 2005)B2274 ACC Monitor Malfunction (from Aug 2005) →