B2275 STSW Monitor Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
This DTC is output when the engine start request signal circuit inside the main body ECU is open or short.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2275 |
Engine start request signal circuit inside main body ECU or other related circuit is malfunctioning |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear the DTCs.
Turn the ignition switch on (IG), wait at least 15 seconds, and check whether DTC B2275 recurs.
- Result:
Display (DTC output)
Proceed To
B2275
A
No DTC output
B
|
|
||||
| A | |
| 2. INSPECT MAIN BODY ECU |
Disconnect the D66 main body ECU connector.

Depress the clutch pedal fully.
Measure the voltage between the ECU terminal and the body ground when operating the ignition switch to crank the engine.
- HINT:
- The voltage is generated at terminal STSW for 0.3 seconds when the engine cranks.
- Standard voltage:
Tester Connections
Specified Conditions
STSW (D66-4) - Body ground
10 to 14 V
Reconnect the main body ECU connector.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
Disconnect the D66 main body ECU connector.

Disconnect the A32 ECM connector.
Check the resistance.
- Standard resistance:
Tester Connection
Specified Condition
STSW (D66-4) - STSW (A32-12)
Below 1 Ω
STSW (D66-4) or STSW (A32-12) - Body ground
10 kΩ or higher
Reconnect the main body ECU connector.
Reconnect the ECM connector.
|
|
||||
| OK | |
| 4. CHECK WHETHER ENGINE STARTS |
Temporarily replace the main body ECU with a new or normally functioning one.
Check that the engine starts normally.
- OK:
- Engine starts normally.
|
|
||||
| OK | ||
| ||
