2005-2008 Yaris · Service Manual ENGINE

B2274 ACC Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

This DTC is output when a malfunction occurs in the ACC output circuit, which is between the ACC cut relay actuation circuit inside the main body ECU and the ACC cut relay.
DTC No.
DTC Detection Condition
Trouble Area
B2274
ACC cut relay actuation circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  2. ACC cut Relay
  3. Wire harness

WIRING DIAGRAM

A122228E01

INSPECTION PROCEDURE


1. READ VALUE OF INTELLIGENT TESTER (ACC RELAY MONITOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body/ Main Body ECU/ Data List / ACC Relay Mon.

  1. Read the display on the tester.

    Main Body ECU:
    Item
    Measurement Item / Display (Range)
    Normal Condition
    ACC Relay Monitor
    ACC relay monitor / ON or OFF
    ON: Ignition switch on (ACC)
    OFF: Ignition switch off

OK:
ON appears on the screen.



NG
Go to step 3
OK


2. CHECK SWITCH CONDITION (IGNITION SWITCH)
  1. Ensure the electrical key is inside the cabin.

  1. Check that the power source mode changes as shown below each time the ignition switch is.

OK:
off → on (ACC) → on (IG) → off



NG
GO TO POWER SOURCE MODE DOES NOT CHANGE
OK

NORMAL

3. INSPECT RELAY (ACC CUT RELAY)

  1. B016200E02
    Remove the ACC cut relay.

  1. Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (When battery voltage applied to terminals 1 and 2)

  1. Reinstall the relay.



NG
REPLACE ACC CUT RELAY
OK


4. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ACC CUT RELAY)

  1. A122227E02
    Remove the ACC cut relay.

  1. Disconnect the D64 main body ECU connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connections
    Specified Conditions
    ACC cut relay (D73-2) - ACCD (D64-4)
    Below 1 Ω

  1. Reinstall the ACC cut relay.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← B2273 Ignition 2 Monitor Malfunction (from Aug 2005)B2275 STSW Monitor Malfunction (from Aug 2005) →