2005-2008 Yaris · Service Manual ENGINE

B2282 Vehicle Speed Signal Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

Also covers:

DESCRIPTION

The main body ECU and the combination meter are connected with a cable and a CAN communication line. DTC B2282 is output when signals, transmitted through the cable and the communication line, do not match.
DTC No.
DTC Detection Condition
Trouble Area
B2282
Following conditions are met:
  1. Signals between main body ECU and combination meter are inconsistent
  1. Malfunction is detected in circuit between vehicle speed sensor and combination meter
  1. Main body ECU
  1. Combination meter
  1. Wire harness
The skid control ECU converts these signals into 4-pulse signals and sends them to the combination meter. After these signal are converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, they are then transmitted to the main body ECU. The main body ECU determines the vehicle speed based on the frequencies of these pulse signals.
DTC No.
DTC Detection Condition
Trouble Area
B2283
When both conditions below are met:
  1. Vehicle speed decreases significantly
  1. Vehicle speed does not correspond with engine speed
  1. Main body ECU
  1. Combination meter
  1. Speed sensor
  1. Skid control ECU
  1. Wire harness
A109248E03

WIRING DIAGRAM

A122430E01

INSPECTION PROCEDURE


1. READ VALUE OF INTELLIGENT TESTER (VEHICLE SPEED SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine and turn the tester ON.

  1. Select the following menu items: Body / Main Body ECU / Data List / Vehicle Spd Sig.

  1. Read the display on the tester.


Main Body ECU:
Item
Measurement Item/Display (Range)
Normal Condition
Diagnostic Note
Vehicle Spd Sig
Vehicle speed signal/ STOP or RUN
STOP: Vehicle is stopped
RUN: Vehicle is running
-

OK:
STOP appears on screen.



NG
Go to step 2
OK

REPLACE MAIN BODY ECU

2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - COMBINATION METER)

  1. A122431E01
    Disconnect the 4C main body ECU connector.

  1. Disconnect the D1 combination meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    4C-8 (SPD) - D1-16 (+S)
    Below 1 Ω
    4C-8 (SPD) or D1-16 (+S) - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK WHETHER ENGINE STARTS
  1. Temporarily replace the main body ECU with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
GO TO COMBINATION METER SYSTEM
OK

END (MAIN BODY ECU IS FAULTY)


← B2278 Engine Switch Circuit Malfunction (from Nov 2005)B2285 Steering Lock Position Signal Circuit Malfunction (+ B2288) (from Nov 2005) →