2005-2008 Yaris · Service Manual ENGINE

B2287 LIN Communication Master Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2006

Also covers:

DESCRIPTION

DTC B2287 is output when there is an abnormal LIN communication circuit between the main body ECU and the certification ECU. DTC B2289 is output when there is a malfunction in the immobiliser system.
DTC No.
DTC Detection Condition
Trouble Area
B2287
Communication or communication line is abnormal between main body ECU and certification ECU
  1. Main body ECU
  2. Certification ECU
  3. Wire harness
B2289
Either of following conditions is met:
  1. Communication or communication line is abnormal among main body ECU, certification ECU, steering lock ECU and ID code box
  2. Immobiliser system malfunctions
  1. Main body ECU
  2. Engine immobiliser system
  3. Wire harness
  4. Engine switch
  5. Entry function
  6. Electrical Key
A122424E10

WIRING DIAGRAM

A122229E21

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU)

  1. A122425E03
    Disconnect the 4D main body ECU connector.

  1. Disconnect the D60 certification ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    4D-9 (LIN1) - D60-10 (LIN)
    Below 1 Ω
    4D-9 (LIN1) or D60-10 (LIN) - Body ground
    10 kΩ or higher

  1. Reconnect the main body ECU connector.

  1. Reconnect the certification ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK CERTIFICATION ECU
  1. Temporarily replace the certification ECU with a new or normally functioning one.

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
REPLACE MAIN BODY ECU
OK

END (CERTIFICATION ECU IS FAULTY)


← B2286 Runnable Signal Malfunction (from Nov 2006)Power Source Mode does not Change (from Nov 2006) →