2005-2008 Yaris · Service Manual ENGINE

B2286 Runnable Signal Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2006

DESCRIPTION

The main body ECU and the ECM are connected by a cable and the CAN communication line. If the cable information and CAN information are inconsistent, this DTC is output.
DTC No.
DTC Detection Condition
Trouble Area
B2286
Cable and CAN information between main body ECU and ECM are inconsistent
  1. Main body ECU
  1. SFI system (2RZ-FE)

WIRING DIAGRAM

A164983E01

INSPECTION PROCEDURE


1. READ VALUE OF INTELLIGENT TESTER (ENGINE CONDITION)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body / Main Body ECU / Data List / E/G Cond.

  1. Read the display on the tester.

    Main Body ECU:
    Item
    Measurement Item/Display (Range)
    Normal Condition
    Diagnostic Note
    E/G Cond
    Engine condition / RUN or STOP
    RUN: Engine running
    STOP: Engine stopped
    -

    OK:
    Engine stopped.



NG
Go to step 2
OK

REPLACE MAIN BODY ECU

2. CHECK WHETHER ENGINE STARTS
  1. Temporarily replace the main body ECU with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
GO TO SFI SYSTEM (2ZR-FE)
OK

END (MAIN BODY ECU IS FAULTY)


← B2285 Steering Lock Position Signal Circuit Malfunction (+ B2288) (from Nov 2006)B2287 LIN Communication Master Malfunction (+ B2289) (from Nov 2006) →