2005-2008 Yaris · Service Manual BODY ELECTRICAL

Driver Side Door Entry Lock Function does not Operate

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

When the touch sensor built into the front door outside handle assembly (driver side) is turned on, a touch sensor ON signal is transmitted to the certification ECU, and a request signal is then transmitted to both the indoor electrical key oscillator and door electrical key oscillator by the certification ECU. Upon receipt of the request signal, the electrical key transmitter transmits an ID code to the certification ECU. When the certification ECU recognizes that the key is not in the cabin and is outside the vehicle, a door lock signal is transmitted to the main body ECU, causing all the doors to be locked.

WIRING DIAGRAM

B127162E01

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. By following the tester screen display, check whether any DTCs are output.

    OK:
    No DTC output.



NG
GO TO DIAGNOSTIC TROUBLE CODE CHART
OK


2. CHECK MANUAL DOOR LOCK OPERATION
  1. Check that the manual door lock function operates normally.

    OK:
    Manual door lock function operates normally.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM
OK


3. CHECK WIRELESS DOOR LOCK AND UNLOCK OPERATION
  1. Check that the wireless door lock and unlock functions operate normally.

    OK:
    Wireless door lock and unlock functions operate normally.



NG
GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (W/ ENTRY AND START SYSTEM)
OK


4. READ VALUE OF DATA LIST (LOCK SWITCH (DRIVER SIDE))
  1. Check the Data List for proper functioning of the door lock switch.

    Certification ECU: 
    Item
    Measurement Item / Range (Display)
    Normal Condition
    Diagnostic Note
    D Trigger SW
    Driver side door lock switch / ON or OFF
    ON: Lock switch is pushed
    OFF: Lock switch is not pushed
    -

    OK:
    ON (lock switch is pushed) appears on the screen.



NG
Go to step 6
OK


5. CHECK OPERATION OF CERTIFICATION ECU ASSEMBLY
  1. After replacing the certification ECU with a normal one, check that the entry lock function operates normally.

    OK:
    Entry lock function operates normally.



NG
REPLACE MAIN BODY ECU
OK

END (CERTIFICATION ECU ASSEMBLY IS DEFECTIVE)

6. INSPECT FRONT DOOR HANDLE ASSEMBLY OUTSIDE (DRIVER SIDE)

  1. B127163E01
    Disconnect the front door outside handle assembly (driver side) connector.

  1. Measure the resistance between the terminals when the trigger switch is operated.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 3
    Switch released
    10 kΩ or higher
    1 - 3
    Switch pressed in
    Below 1 Ω

  1. Reconnect the door handle connector.



NG
REPLACE FRONT DOOR HANDLE ASSEMBLY OUTSIDE (DRIVER SIDE)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Front Passenger Side Door Entry Lock and Unlock Functions do not Operate (from Aug 2005)Front Passenger Side Door Entry Lock Function does not Operate (from Aug 2005) →