2005-2008 Yaris · Service Manual STEERING

Unlock Position Sensor Signal Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

The steering lock ECU sends an unlock position signal to the main body ECU. On receiving the signal, the main body ECU permits engine start. (This prevents the engine from being started with the steering locked.)
The diagnosis information of the steering lock ECU is transmitted to the tester via the certification ECU as the steering lock ECU is not connected to the CAN communication system.

WIRING DIAGRAM

C117907E01

INSPECTION PROCEDURE

HINT:
  1. Before starting the inspection by using the intelligent taster with the engine switch off, make sure that the driver door is open.
  2. When the engine switch is off, the main body ECU may not be working.
  3. Communication with the intelligent tester is impossible if the main body ECU is not working.


1. INSPECT STEERING LOCK ACTUATOR ASSEMBLY

  1. C104383E05
    Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition (Steering lock position)
    Specified Condition
    SLP1 (D56-4) - SGND (D56-2)
    Lock
    ↓↑
    Unlock
    10 to 14 V
    ↓↑
    Below 1 V



OK
Go to step 4
NG


2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BODY GROUND)

  1. C122327E02
    Disconnect the connector from the steering lock actuator assembly.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    GND (D56-1) - Body ground
    Always
    Below 1 Ω
    SGND (D56-2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY POWER SOURCE - BODY GROUND)

  1. C122327E05
    Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    B (D56-7) - SGND (D56-2)
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE STEERING LOCK ACTUATOR ASSEMBLY

4. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - MAIN BODY ECU)

  1. C124982E02
    Disconnect the connectors from the steering lock actuator assembly and the main body ECU.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    SLP (D64-18) - SLP1 (D56-4)
    Always
    Below 1 Ω
    SLP1 (D56-4) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

CHECK PUSH BUTTON START SYSTEM


← Steering Lock Motor Drive Power Circuit (from Nov 2005)Unable to Unlock Steering Wheel (from Aug 2005) →