B2286 Runnable Signal Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
The main body ECU and the ECM are connected by a cable and the CAN communication line. If the cable information and CAN information are inconsistent, this DTC is output.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2286 |
Cable and CAN information between main body ECU and ECM are inconsistent |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE OF INTELLIGENT TESTER (ENGINE CONDITION) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Main Body ECU / Data List / E/G Cond.
Read the display on the tester.
- Main Body ECU:
Item
Measurement Item/Display (Range)
Normal Condition
Diagnostic Note
E/G Cond
Engine condition / RUN or STOP
RUN: Engine running
STOP: Engine stopped
-
- OK:
- Engine stopped.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
Disconnect the D66 main body ECU connector.

Disconnect the A32 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
D66-2 (TACH) - A32-32 (TACH)
Below 1 Ω
D66-2 (TACH) or A32-32 (TACH) - Body ground
10 kΩ or higher
Reconnect the main body ECU connector.
Reconnect the ECM connector.
|
|
||||
| OK | |
| 3. CHECK WHETHER ENGINE STARTS |
Temporarily replace the main body ECU with a new or normally functioning one.
Check that the engine starts normally.
- OK:
- Engine starts normally.
|
|
||||
| OK | ||
| ||
