B2287 LIN Communication Master Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2005
Also covers:
- B2289 Key Collation Waiting Time Over
DESCRIPTION
DTC B2287 is output when there is an abnormal LIN communication circuit between the main body ECU and the certification ECU. DTC B2289 is output when there is a malfunction in the immobiliser system.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2287 |
Communication or communication line is abnormal between main body ECU and certification ECU |
|
| B2289 |
Either of following conditions is met:
|
|


WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU) |
Disconnect the 4D main body ECU connector.

Disconnect the D60 certification ECU connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
4D-9 (LIN1) - D60-10 (LIN)
Below 1 Ω
4D-9 (LIN1) or D60-10 (LIN) - Body ground
10 kΩ or higher
Reconnect the main body ECU connector.
Reconnect the certification ECU connector.
|
|
||||
| OK | |
| 2. CHECK CERTIFICATION ECU |
Temporarily replace the certification ECU with a new or normally functioning one.
Check for DTCs again.
- OK:
- No DTC is output.
|
|
||||
| OK | ||
| ||
