2005-2008 Yaris · Service Manual BODY ELECTRICAL

Radio Receiver Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM

E118193E01
E118194E01

INSPECTION PROCEDURE


1. INSPECT FUSE (ACC, AM1, DOME)
  1. Remove the ACC fuse and AM1 fuse from the main body ECU.

  1. Remove the DOME fuse from the engine room R/B.

  1. Measure the resistance of the fuses.

    Standard Resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BATTERY AND BODY GROUND)
E106746E05
  1. Disconnect the D10 radio receiver connector.

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    D10-4 (B) - Body ground
    Always
    10 to 14 V
    D10-3 (ACC) - Body ground
    Ignition switch on (ACC)
    10 to 14 V

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D10-7 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Speaker Circuit (from Jan 2006)COMPONENTS (from Jan 2006) →