2005-2008 Yaris · Service Manual BODY

Power Windows do not Operate at All

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

If all of the power windows do not operate, the power window regulator master switch may have no power or may be malfunctioning.

WIRING DIAGRAM

B119964E02

INSPECTION PROCEDURE


1. INSPECT FUSES (ECU-B, ECU-IG)

  1. B128295E01
    Remove the ECU-B fuse from the engine room relay block.

  1. Remove the ECU-IG fuse from the main body ECU.

  1. Measure the resistance.

    Standard resistance:
    Below 1Ω

  1. Reinstall the fuses.



NG
REPLACE FUSE
OK


2. INSPECT MAIN BODY ECU (PWR RELAY)

  1. B119965E01
    Remove the POWER fuse from the main body ECU.

  1. Turn the ignition switch to ON.

  1. Turn the ignition switch ON.

  1. Measure the voltage between the POWER fuse terminal of the main body ECU and body ground.

    Standard voltage:
    Tester Connections
    Ignition Switch Conditions
    Specified Conditions
    POWER fuse terminal (1) - Body ground
    ON
    10 to 14 V

  1. Reinstall the POWER fuse.



NG
REPLACE MAIN BODY ECU (PWR RELAY)
OK


3. CHECK HARNESS AND CONNECTOR (POWER WINDOW MASTER SWITCH - BATTERY AND BODY GROUND)

  1. B129851E01
    Disconnect the G1 or F7 power window regulator master switch connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    w/o rear power window
    LHD 
    Tester Connection
    Condition
    Specified Condition
    G1-15 (B)- Body ground
    Ignition switch ON
    10 to 14 V
    RHD 
    Tester Connection
    Condition
    Specified Condition
    F7-15 (B)- Body ground
    Ignition switch ON
    10 to 14 V


    Standard voltage:
    w/ rear power window
    LHD 
    Tester Connection
    Condition
    Specified Condition
    G1-6 (B)- Body ground
    Ignition switch ON
    10 to 14 V
    RHD 
    Tester Connection
    Condition
    Specified Condition
    F7-6 (B)- Body ground
    Ignition switch ON
    10 to 14 V

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    w/o rear power window
    LHD 
    Tester Connection
    Specified Condition
    G1-7 (E)- Body ground
    Below 1 Ω
    RHD 
    Tester Connection
    Specified Condition
    F7-7 (E)- Body ground
    Below 1 Ω


    Standard resistance:
    w/ rear power window
    LHD 
    Tester Connection
    Specified Condition
    G1-1 (E)- Body ground
    Below 1 Ω
    RHD 
    Tester Connection
    Specified Condition
    F7-9 (E)- Body ground
    Below 1 Ω

  1. Reconnect the power window regulator master switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


← Rear Power Window RH does not Operate with Rear Power Window Switch RH (from Aug 2005)COMPONENTS (from Jan 2006) →