ECU Power Source Circuit
Circuit diagnosis · Vehicles built from Aug 2005
DESCRIPTION
This circuit provides power to operate the transponder key ECU assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FUSE (ECU-B) |
Remove the ECU-B fuse from the engine room R/B and J/B.

Measure the ECU-B fuse resistance.
- Standard resistance:
- Below 1 Ω
Reinstall the ECU-B fuse.
|
|
||||
| OK | |
| 2. INSPECT FUSE (IGN) |
Remove the IGN fuse from the main body ECU.

Measure the IGN fuse resistance.
- Standard resistance:
- Below 1 Ω
Reinstall the IGN fuse.
|
|
||||
| OK | |
| 3. INSPECT INTEGRATION RELAY (IG2 RELAY AND AM2 FUSE) |
Remove the integration relay from the engine room relay block.

Inspect the AM2 fuse.
Remove the AM2 fuse from the integration relay.
Measure the resistance.
- Standard resistance:
- Below 1 Ω
Reinstall the AM2 fuse.
Inspect the IG2 relay.
Measure the resistance.
- Standard resistance:
Tester Connections
Specified Conditions
1C-1 - 1B-4
10 kΩ or higher
Below 1 Ω (when battery voltage is applied to terminals 1B-2 and 1B-3)
1C-1 - 1B-1
Below 1 Ω
Reinstall the integration relay.
|
|
||||
| OK | |
| 4. INSPECT IGNITION SWITCH ASSEMBLY |
Disconnect the D8 ignition switch connector.

Measure the resistance between the terminals shown below.
- Standard resistance:
Key Position
Tester Connection
Specified Condition
LOCK
-
10 kΩor higher
ACC
2 - 4
Below 1 Ω
ON
1 - 2 - 4
Below 1 Ω
5 - 6
Below 1 Ω
START
1 - 3 - 4
Below 1 Ω
5 - 6 - 7
Below 1 Ω
Reconnect the ignition switch connector.
|
|
||||
| OK | |
| 5. CHECK WIRE HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND) |
Disconnect the D23 transponder key ECU connector.

Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Condition
Specified Condition
D23-1 (+B) - Body ground
Always
11 to 14 V
D23-2 (IG) - Body ground
Ignition switch OFF
Below 1 V
Ignition switch ON
11 to 14 V
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
D23-16 (GND) - Body ground
Below 1 Ω
Reconnect the transponder key ECU connector.
|
|
||||
| OK | ||
| ||
