2005-2008 Yaris · Service Manual SECURITIES

Security Indicator Light Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

When the transponder key is registered, the transponder key ECU assembly indicates the key registration condition by lighting up, blinking or turning off the security indicator.

WIRING DIAGRAM

B116299E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST BY INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on.

  1. Perform the ACTIVE TEST according to the display on the tester.

    Transponder Key ECU 
    Item
    Tester Details
    Diagnostic Note
    Security Indic
    Turn security indicator ON/OFF
    -

    OK:
    Security indicator comes on and goes off.



OK
Go to step 3
NG


2. CHECK WIRE HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - SECURITY INDICATOR LIGHT)

  1. B115782E01
    Disconnect the D23 transponder key ECU and D25 security indicator connectors.

  1. Measure the resistance.

    Standard resistance:
    Tester Condition
    Specified Condition
    D23-8 (IND) - D25-2 (LP)
    Below 1Ω
    D23-8 (IND) - Body ground
    10 kΩor higher

  1. Reconnect the transponder key ECU and security indicator connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT TRANSPONDER KEY ECU ASSEMBLY

  1. B087039E01
    Remove the transponder key ECU assembly with its connectors still connected.

  1. Measure the voltage.

    Standard voltage:
    Tester Condition
    Condition
    Specified Condition
    D23-8 (IND) - Body ground
    Immobiliser set
    11 to 14 V and below 1 V output alternately

  1. Reinstall the transponder key ECU assembly.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

REPLACE SECURITY INDICATOR LIGHT


← B2799 Engine Immobiliser System Malfunction (from Aug 2005)ECU Power Source Circuit (from Aug 2005) →