DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Aug 2005
| DESCRIPTION |
The ECM controls the vehicle immobiliser system functions. Immobiliser system data and the DTCs can be read through the vehicles DLC3.
In some cases, a malfunction may occur in the immobiliser system even though the security indicator light is not illuminated. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.
| CHECK DLC3 |
The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.

Symbols (Terminals No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus " +" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
11 to 14 V
CANH (6) - CANL (14)
HIGH-level CAN bus line
Ignition switch OFF*
54 to 69 Ω
CANH (6) - CG (4)
HIGH-level CAN bus line
Ignition switch OFF*
200 Ω or more
CANL (14) - CG (4)
LOW-level CAN bus line
Ignition switch OFF*
200 Ω or more
CANH (6) - BAT (16)
HIGH-level CAN bus line
Ignition switch OFF*
6 kΩ or more
CANL (14) - BAT (16)
LOW-level CAN bus line
Ignition switch OFF*
6 kΩ or more
- NOTICE:
- *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors.
- HINT:
-


- Connect the cable of the intelligent tester to the DLC3, turn the ignition switch on (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
- If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
- If communication is still not possible when the tester is connected to another vehicle, the problem is probably in the tester itself. Consult the Service Department listed in the tester's instruction manual.
- If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
| INSPECT BATTERY VOLTAGE |
Inspect the battery voltage.
- Standard voltage:
- 11 to 14 V