2005-2008 Yaris · Service Manual SECURITIES

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built from Nov 2006


OUTLINE OF THEFT DETERRENT SYSTEM
  1. When any attempt is made to forcibly enter the vehicle, open the engine hood or unlock any door without using a wireless key, or when the battery terminals are disconnected and then reconnected, this system causes the vehicle horn and security horn to sound, the interior light to light up, and the hazard warning lights to flash, in order to deter break-in and theft.

  2. Each mode has 4 states; a disarmed state, an arming preparation state, an armed state and an alarm sounding state.

    1. Disarmed state:

      1. The alarm function is not operating.
      2. The theft deterrent system is not operating.

    2. Arming preparation state:

      1. The state before the system goes into the armed state.
      2. The theft deterrent system is not operating.

    3. Armed state:

      1. The theft deterrent system is operating.

    4. Alarm sounding state:

      1. The alarm function is operating.

        Alarm time:
        Approximately 27.5 seconds.

      Alarm from manifestation and duration: 
      Alarm Form
      Hazard Warning Light
      Blinks (Cycle of flasher relay)
      Interior Light
      Illuminates
      Vehicle Horn
      Sounds
      (approximately 0.4 seconds cycles)
      Security Horn
      Sounds
      (approximately 0.4 seconds cycles)
      Alarm Duration
      Approximately 27.5 seconds


ARMING MODE

HINT:
  1. Active arming mode starts the alarm control immediately after the doors are locked.
  2. This system activates as described in the diagram below when one item for each condition is met.

  1. Arming mode
    B112141E01

    HINT:
    The terms "all doors", "any door" and "door" include the back door.

    Condition
    Item
    Condition (1)
    In the disarmed state, when the key is not in the actual area, the system state is switched if the following conditions is met. With all doors and engine hood closed, lock all doors by wireless operation.
    Condition (2)
    1. After condition (1) met, 30 seconds allowed to enter armed state.
    Condition (3)
    One of following operations performed within 30 seconds of entering arming preparation state:
    1. Any door unlocked.
    2. Any door opened.
    3. Engine hood opened.
    4. Turn the engine switch from off to on (IG).
    5. Battery reconnected.
    Condition (4)
    One of following operations performed in armed state:
    1. Any door opened.
    2. Engine hood opened.
    3. Battery reconnected.
    4. Any door unlocked without wireless operation.
    Condition (5)
    One of following operations performed in alarm sounding state:
    1. Unlock all doors by wireless operation.
    2. Turn the engine switch on (IG) and run the engine Approximately 2 seconds.
    Condition (6)
    1. After approximately 27.5 seconds, alarm stops sounding and system returns to armed state.


FORCED DOOR LOCK CONTROL
  1. The forced door lock control prevents the vehicle from being tampered with. Immediately after a door is unlocked (alarm starts), the door is forced to lock by a forced door lock signal.

    1. Conditions that force the doors to lock:
      When the key is not in the actuation area and both of the following conditions are met.

      1. The theft deterrent system is in the alarm sounding state of active arming mode.
      2. Any door is unlocked.

      HINT:
      Forced door lock control does not operate if any door is unlocked by wireless key operation.


SECURITY INDICATOR OUTPUT
  1. The theft warning ECU outputs a signal to light up the security indicator, according to the state of the theft deterrent system. However, some of the actual lighting conditions of the security indicator are different from the output signals of the theft warning ECU.

    Output: 
    Theft Deterrent System Condition
    Security Indicator
    Output Signals from Theft Warning ECU
    Actual Lighting Condition
    Disarmed state (1), (2)
    OFF
    OFF (immobiliser system unset)
    BLINKING (immobiliser system set)
    Arming preparation state
    ON
    ON
    Armed state
    BLINKING (w/ entry and start system)
    OFF (w/o entry and start system)
    BLINKING
    Alarm sounding state
    ON
    ON
    Blinking cycle: 
    Time
    Security Indicator
    0.2 seconds
    ON
    1.8 seconds
    OFF

    HINT:
    When the immobiliser system is set, the security indicator blinks during both the disarmed state and the armed state, due to the output signals from the immobiliser system.

← SYSTEM DIAGRAM (from Nov 2006)HOW TO PROCEED WITH TROUBLESHOOTING (from Nov 2006) →