2005-2008 Yaris · Service Manual SECURITIES

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Nov 2006

HINT:
  1. Use this procedure to troubleshoot the theft deterrent system.
  2. The intelligent tester should be used in steps 3 and 5.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      HINT:
      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT

    3.CHECK FOR DTC
    1. Check for DTCs and note any codes that are output.

    2. Delete the DTCs.

    3. Check whether the same DTCs recur by simulating the conditions indicated by the DTCs noted in step (a) above.

      Result
      Proceed To
      No DTC output
      A
      DTC output
      B


    B.
    A

    4.PROBLEM SYMPTOMS TABLE
      Result: 
      Result
      Proceed To
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B

    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Data list/Active test (Click here)

    2. Terminals of ECU (Click here)

    3. System Description (Click here)

    NEXT

    6.REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Nov 2006)PROBLEM SYMPTOMS TABLE (from Nov 2006) →