REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1. REMOVE MULTI-MODE MANUAL TRANSAXLE ASSEMBLY |
| 2. REMOVE SHIFT STROKE SENSOR |
![]() ![]() |
Remove the 2 screws and the sensor from the shift and select actuator.
Remove the O-ring from the sensor.
| 3. REMOVE CLUTCH RELEASE FORK |
![]() ![]() |
Remove the clip from the release bearing.
Remove the release bearing from the clutch release fork.
Remove the E-ring from the fork lever.

Remove the fork lever and fork.
| 4. REMOVE CLUTCH RELEASE FORK LEVER SHAFT OIL SEAL |
![]() ![]() |
Using a screwdriver, remove the oil seal.
| 5. REMOVE CLUTCH COVER ASSEMBLY |
![]() ![]() |
Place matchmarks on the flywheel and clutch cover.
Loosen each set bolt one turn at a time until the spring tension is released.
Remove the 6 bolts, and pull off the clutch cover with the clutch disc.
- NOTICE:
- Do not drop the clutch disc.
- When replacing the clutch disc, be sure to replace it together with the clutch cover as a set.
- Do not drop the clutch disc.




