2005-2008 Yaris · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL FRONT DIFFERENTIAL CASE

  1. G021409
    Install the appropriate thrust washers and side gears. Refer to the table below and select thrust washers that bring the backlash to within the specifications. Select washers of the same size for both sides.

    Standard backlash:
    0.05 to 0.20 mm (0.0020 to 0.0079 in.)

    Thickness mm (in.)
    Thickness mm (in.)
    0.50 (0.0197)
    0.75 (0.0295)
    0.55 (0.0217)
    0.80 (0.0315)
    0.60 (0.0236)
    0.85 (0.0335)
    0.65 (0.0256)
    0.90 (0.0354)
    0.70 (0.0276)
    0.95 (0.0374)

  1. G021410
    Install the thrust washers and the side gears into the differential case.

  1. G021411
    Install the pinion shaft.

  1. G021412
    Using a dial indicator, check the side gear backlash. Measure the side gear backlash while holding one pinion gear toward the differential case.

    Standard backlash:
    0.05 to 0.20 mm (0.0020 to 0.0079 in.)

    If the backlash is not within the specification, install a thrust washer of a different thickness.

  1. G021414
    Using a pin punch and a hammer, install the pinion shaft slotted spring pin through the front differential case and the hole in the pinion shaft.

  1. G021556
    Using a chisel and hammer, caulk the pin holes around the circumference of the front differential case.


2. INSTALL FRONT DIFFERENTIAL RING GEAR

  1. C058905E07
    Using a heater, heat the front differential ring gear to 90 to 110°C (194 to 230°F).

  1. Clean the contact surface of the front differential case.

  1. G021558E05
    Aligning the matchmarks, quickly install the front differential ring gear onto the front differential case with the 6 bolts.

    Torque:
    124 N*m{ 1,260 kgf*cm , 91 ft.*lbf }


3. INSTALL FR DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING

  1. G021559E01
    Using SST and a press, install the front differential case rear tapered roller bearing.
    SST
    09350-32014   (09351-32120, 09351-32140)


4. INSTALL FR DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING

  1. F100233E01
    Using SST and a press, install the front differential case front tapered roller bearing.
    SST
    09350-32014   (09351-32120, 09351-32140)

← DISASSEMBLY (from Nov 2005)COMPONENTS (from Nov 2005) →