Parking Brake Switch Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
The transmission control ECU detects the ON/OFF status of the parking brake switch. When the parking brake is applied, the parking brake switch turns ON. When the parking brake is released, the switch turns OFF.- HINT:
- When the brake pedal is not depressed with the gear in 1st, 2nd or reverse, the clutch is half-engaged, even if the accelerator pedal is not depressed. As a result, the vehicle can creep slowly like an automatic transmission vehicle. This assists the vehicle in preparing to move. The take off assist control is cancelled while the parking brake switch is ON.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT PARKING BRAKE SWITCH ASSEMBLY |
![]() ![]() |
Remove the parking brake switch assembly.
Check the parking brake switch resistance.
- Standard resistance:
Tester Connections
Switch Position
Specified Conditions
1 - Switch body
OFF
(When shaft pressed)
10 kΩ or higher
1 - Switch body
ON
(When shaft released)
Below 1 Ω
Reinstall the parking brake switch assembly.
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL ECU - BODY GROUND) |
![]() ![]() |
Disconnect the transmission control ECU connector.
Check the resistance.
- Standard resistance:
Tester Connections
Switch Conditions
Specified Conditions
PKB (D79-4) - Body ground
OFF
10 kΩ or higher
PKB (D79-4) - Body ground
ON
Below 1 Ω
Reconnect the transmission control ECU connector.
|
|
||||
| OK | |
| 3. INSPECT TRANSMISSION CONTROL ECU ASSEMBLY |
![]() ![]() |
Turn the ignition switch on (IG).
Measure the voltage between the terminal of the transmission control ECU connector and the body ground when the parking brake switch is ON and OFF.
- Standard voltage:
Tester Connections
Switch Conditions
Specified Conditions
PKB (D79-4) - Body ground
OFF
10 to 14 V
PKB (D79-4) - Body ground
ON
Below 1 V
|
|
||||
| OK | ||
| ||



