2005-2008 Yaris · Service Manual TRANSMISSION

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Terminal TC and CG are located in the DLC3. When performing [Clamp Position Adjustment] and [Initialization and Learning] without using an intelligent tester, connecting terminals TC and CG is necessary. If the TC terminal circuit is open, these calibration procedures cannot be performed without using an intelligent tester.

WIRING DIAGRAM

C111583E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL ECU - DLC3)

  1. C127420E01
    Disconnect the transmission control ECU connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connections
    Specified Conditions
    DG (D79-25) - TC (D15-13)
    Below 1 Ω
    DG (D79-25) - Body ground
    10 kΩor higher

  1. Reconnect the transmission control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

  1. C127419E01
    Check the resistance.

    Standard resistance:
    Tester Connections
    Specified Conditions
    CG (D15-4) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSMISSION CONTROL ECU ASSEMBLY


← Parking Brake Switch Circuit (from Nov 2005)ON-VEHICLE INSPECTION (from Nov 2005) →