2005-2008 Yaris · Service Manual TRANSMISSION

Parking Brake Switch Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The transmission control ECU detects the ON/OFF status of the parking brake switch. When the parking brake is applied, the parking brake switch turns ON. When the parking brake is released, the switch turns OFF.

HINT:
When the brake pedal is not depressed with the gear in 1st, 2nd or reverse, the clutch is half-engaged, even if the accelerator pedal is not depressed. As a result, the vehicle can creep slowly like an automatic transmission vehicle. This assists the vehicle in preparing to move. The take off assist control is cancelled while the parking brake switch is ON.


WIRING DIAGRAM

C111586E01

INSPECTION PROCEDURE


1. INSPECT PARKING BRAKE SWITCH ASSEMBLY
C112729E01
  1. Remove the parking brake switch assembly.

  1. Check the parking brake switch resistance.

    Standard resistance:
    Tester Connections
    Switch Position
    Specified Conditions
    1 - Switch body
    OFF
    (shaft pressed)
    10 kΩ or higher
    1 - Switch body
    ON
    (shaft released)
    Below 1 Ω

  1. Reinstall the parking brake switch assembly.



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY
OK


2. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL ECU - BODY GROUND)
C112718E08
  1. Disconnect the transmission control ECU connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connections
    Switch Conditions
    Specified Conditions
    PKB (D79-4) - Body ground
    OFF
    10 kΩ or higher
    PKB (D79-4) - Body ground
    ON
    Below 1 Ω

  1. Reconnect the transmission control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT TRANSMISSION CONTROL ECU ASSEMBLY
C112714E20
  1. Turn the ignition switch on (IG).

  1. Measure the voltage between the terminal of the transmission control ECU connector and the body ground when the parking brake switch is ON and OFF.

    Standard voltage:
    Tester Connections
    Switch Conditions
    Specified Conditions
    PKB (D79-4) - Body ground
    Parking brake switch
    OFF
    10 to 14 V
    PKB (D79-4) - Body ground
    Parking brake switch
    ON
    Below 1 V



NG
REPLACE TRANSMISSION CONTROL ECU ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Multi-Mode Manual Transmission Warning Light Circuit (from Nov 2005)TC and CG Terminal Circuit (from Nov 2005) →