2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL CLUTCH STROKE SENSOR

C129958E01
  1. Apply MP grease to a new O-ring.

  1. Install the new O-ring onto the stroke sensor.

  1. Set the stroke sensor so that the sensor side and the actuator side sensor arms are in the positions shown in the illustration.

  1. D032654
    Turn the stroke sensor clockwise and fix it with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Connect the clutch stroke sensor connector.


2. INSTALL AIR CLEANER ASSEMBLY

  1. A125745
    Install the air cleaner case sub-assembly with air cleaner inlet with the 3 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }


3. INSTALL NO.1 AIR CLEANER HOSE

  1. C127625
    Connect the No. 1 air cleaner hose with the 2 clips.

  1. Connect the 2 fuel hoses.

  1. Connect the No. 1 air cleaner hose with the clamp.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


5. PERFORM INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION ECU
(Click here)

6. PERFORM LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
(Click here)

7. PERFORM SYNCHRONIZATION POSITION CALIBRATION
(Click here)
← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →