2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL CLUTCH ACTUATOR ASSEMBLY

NOTICE:
Perform the following procedure ((1) to(5)) to set a new clutch actuator in the clutch clamp position because it is not originally placed in that position.
(1) Connect the clutch stroke sensor connector and motor connector to the clutch actuator.
(2) Connect the battery negative terminal.
(3) Perform clutch position adjustment (clutch clamp position)
(Click here)
(4) Disconnect the battery negative terminal.
(5) Disconnect the clutch stroke sensor connector and motor connector.

  1. D032731E01
    Apply grease to the clutch release lever.

    Sealant:
    MULTEMP 8158 GREASE or equivalent

  1. Set the clutch actuator to the transaxle and provisionally tighten the 3 bolts.

  1. D032655
    Lightly move the clutch actuator assembly toward the left of the vehicle while holding it lightly to prevent tilting until the convex part of the rod nut and the concave part the release fork make contact.

    NOTICE:
    1. Do not apply strong force until the convex part of the rod nut and the concave part of the release fork make contact.
    2. Ensure that the convex part is securely fitted to the concave part.

  1. D032657E01
    Tighten the 3 bolts by hand while holding the clutch actuator assembly.

    NOTICE:
    Support the clutch actuator assembly until all 3 bolts are tightened.

  1. Tighten the 3 bolts to the specified torque in the order A, B, and C, as shown.

    Torque:
    17 N*m{ 173 kgf*cm , 13 ft.*lbf }

  1. Connect the clutch stroke sensor connector and motor connector.


2. INSTALL AIR CLEANER ASSEMBLY

3. INSTALL NO.1 AIR CLEANER HOSE

  1. C127625
    Connect the No. 1 air cleaner hose with the 2 clips.

  1. Connect the 2 fuel hoses.

  1. Connect the No. 1 air cleaner hose with the clamp.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


5. PERFORM INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION ECU
(Click here)

6. PERFORM LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
(Click here)

7. PERFORM SYNCHRONIZATION POSITION CALIBRATION
(Click here)
← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →