REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1. CLUTCH POSITION ADJUSTMENT |
- NOTICE:
- Remove the clutch actuator with the rod in the clutch position. Otherwise, it may cause clutch slipping or operational malfunctions when reinstalling.
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE AIR CLEANER INLET NO.1 (for 2SZ-FE) |
![]() ![]() |
Remove the air cleaner inlet No. 1.
| 4. REMOVE BATTERY HOLD DOWN CLAMP |
| 5. REMOVE BATTERY |
| 6. REMOVE BATTERY TRAY |
| 7. REMOVE BATTERY CARRIER (for 1KR-FE) |
![]() ![]() |
Remove the 4 bolts and the battery carrier.
| 8. REMOVE BATTERY CARRIER (for 2SZ-FE) |
![]() ![]() |
Remove the 5 bolts and the battery carrier.
| 9. REMOVE CLUTCH ACTUATOR ASSEMBLY |
![]() ![]() |
Remove the bolt and separate the wire harness bracket.
Disconnect the clutch stroke sensor connector and motor connector.

- NOTICE:
- Do not forcibly pull the connector as this may damage the wire harness.
Remove the 3 bolts and clutch actuator assembly.

- NOTICE:
- Loosen the bolts slowly, and be careful not to get your fingers caught as the clutch actuator assembly moves due to the reaction force from the clutch cover.
- Do not drop the removed clutch actuator assembly or subject it to any impacts.
- Loosen the bolts slowly, and be careful not to get your fingers caught as the clutch actuator assembly moves due to the reaction force from the clutch cover.




