2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE REAR GENERATOR END COVER

A128377
  1. Using a torx socket wrench(T25), remove the 2 bolts from the rear generator end cover.

  1. Remove the screw, then remove the rear generator end cover.


2. REMOVE REGULATOR SUB-ASSEMBLY GENERATOR WITH BRUSH

A128378
  1. Remove the 3 screws, then remove the regulator sub-assembly generator with brush.


3. REMOVE STATOR SUB-ASSEMBLY GENERATOR WITH RECTIFIER

A128379
  1. Remove the 4 bolts.

  1. A128380
    Using a screwdriver with its tip wrapped in protective tape, pry out the stator sub-assembly generator with rectifier.


4. REMOVE BEARING SET GENERATOR

A128381

5. REMOVE GENERATOR WITH CLUTCH PULLEY
  1. Using a screwdriver, remove the generator pulley cap from the generator with clutch pulley.

  1. Clamp the swivel arm in a vise.

    NOTICE:
    Do not clamp the generator rotor in the vise.

  1. A128382E01
    Using a SST and an 8 mm bi-hexagon wrench, remove the generator with clutch pulley.
    SST
    09820-63020  


6. REMOVE GENERATOR ROTOR ASSEMBLY

A128383
  1. Using a press, press out the generator rotor assembly and spacer ring.

← REMOVAL (from Nov 2005)INSPECTION (from Nov 2005) →