REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE ENGINE UNDER COVER
|
 |
Remove the 5 bolts, 4 screws and 2 clips and remove the engine under cover.
| 3.
REMOVE ENGINE COVER SUB-ASSEMBLY NO. 1
|
 |
- Disengage the 4 pins and remove engine cover No. 1.
| 4.
SEPARATE ENGINE WIRE |
 |
- Disconnect the camshaft position sensor connector.
Remove the 2 bolts and separate the engine wire.
| 5.
REMOVE FAN AND GENERATOR V BELT
|
 |
Remove the 3 bolts and clip, then separate the wire harness.
- Loosen bolts A and B.
Remove the fan and generator V belt.
| 6.
REMOVE GENERATOR ASSEMBLY |
 |
Remove the terminal cap.
Separate the connector and harness clamp.
Remove the nut and remove terminal B.
- Remove fan belt adjusting slider fixing bolt A and nut B and remove the fan belt adjusting slider.
- Remove fixing bolt C and remove the generator.