2005-2008 Yaris · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL GENERATOR ROTOR ASSEMBLY

A128388
  1. Using SST and a press, press in the generator rotor assembly.

    SST
    09285-76010  

    NOTICE:
    Avoid misalignment during pressing.


2. INSTALL GENERATOR WITH CLUTCH PULLEY

A128389
  1. Install the spacer ring.

  1. A128390E01
    Using a SST and an 8 mm bi-hexagon wrench, install the generator with clutch pulley.
    SST
    09820-63020  

    Torque:
    65 N*m{ 663 kgf*cm , 48 ft.*lbf }

  1. Install the generator pulley cap.


3. INSTALL BEARING SET GENERATOR

A128391E01
  1. Align the 3 cutouts of the stator sub-assembly with rectifier with the protrusions of the bearing set generator.


4. INSTALL STATOR SUB-ASSEMBLY GENERATOR WITH RECTIFIER

A128379
  1. Align the key of the drive end frame with the keyway of the stator sub-assembly generator with rectifier.

  1. Install the stator generator with rectifier with the 4 bolts.

    Torque:
    4.3 N*m{ 44 kgf*cm , 38 in.*lbf }


5. INSTALL REGULATOR SUB-ASSEMBLY GENERATOR WITH BRUSH

A128392
  1. Attach the brushes and terminals to the rectifier end frame of the regulator generator with brush.

  1. Install the regulator generator with brush with the 3 screws.

    HINT:
    Install screw B into the position shown in the illustration.


    A128393E01

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf } for screw A
    1.2 N*m{ 12 kgf*cm , 11 in.*lbf } for screw B


6. INSTALL REAR GENERATOR END COVER

A128377
  1. Install the generator rear end cover with the 2 bolts and screw.

    Torque:
    13 N*m{ 132 kgf*cm , 9.6 ft.*lbf } for bolt
    2.8 N*m{ 29 kgf*cm , 25 in.*lbf } for screw

← INSPECTION (from Nov 2005)INSTALLATION (from Nov 2005) →