P0725 Engine Speed Input Circuit
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The ECM detects the engine revolution signals (NE) using the crankshaft position (CKP) sensor. The transmission control ECU controls the transmission in accordance with two engine revolution signals. One signal is received directly from the ECM through a serial communication line. The other signal is received from the ECM via the Controller Area Network (CAN) communication. If the transmission control ECU detects no engine revolution signals despite the engine revolution signal via CAN being received while the vehicle is running, the ECU interprets this as a malfunction in the engine revolution signal circuit. The ECU sets the DTC and illuminates the multi-mode manual transmission warning light.| DTC No. |
DTC Detection Conditions |
Trouble Areas |
| P0725 |
The transmission control ECU detects the following conditions simultaneously: (1 trip detection logic)
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- In ECM replacement, perform the REGISTRATION (Injector compensation codes) after installing the ECM (Click here)
| 1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0725) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Powertrain / Multi-Mode M/T / DTC.
Read DTCs and write them down.
Select the following menu items: Powertrain / Engine and ECT.
Read DTCs.
- Result:
Display (DTC Output)
Proceed To
P0725
A
P0725 and P0335
B
|
|
||||
| A | |
| 2. INSPECT TRANSMISSION CONTROL ECU ASSEMBLY |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Powertrain / Multi-Mode M/T / Data List / Backup Engine Speed.
Check the engine speed value displayed on the tester.
Items
[Abbreviation]
Measurement Items: Display
Normal Conditions
Diagnostic Notes
Backup Engine Speed
[Bacup Engin Spd]
Back-up engine speed:
Min.: 0 rpm, Max.: 8,160 rpm
720 to 820 rpm: Idling
0 rpm: Engine stopped
0 rpm displayed when malfunction in CAN communication
Connect the oscilloscope probes to the NE terminal and the body ground.

Check the signal waveform.
Tester settings Items
Contents
Terminals
CH1: NE (A38-10) - Body ground
Equipment Settings
5 V/DIV, 5 ms/DIV
Condition
Engine idling
- OK:
- When the Backup Engine Speed indicates an idling speed on the intelligent tester, a waveform similar to that in the illustration is output.
|
|
||||
| NG | |
| 3. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL ECU - ECM) |
![]() ![]() |
Disconnect the transmission control ECU connector.
Disconnect the ECM connector.
Check the resistance.
- Standard resistance:
Tester connections
Specified Conditions
NE (A38-10) - NEO (A49-22)
Below 1 Ω
NE (A38-10) - Body ground
10 kΩ or higher
Reconnect the transmission control ECU connector.
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||

