2005-2008 Yaris · Service Manual TRANSMISSION

P0821 Gear Lever "X" Position Circuit

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

Based on the signal from the transmission shift main switch, the transmission control ECU detects whether the shift lever position is in the E or M position. If the transmission shift main switch is ON despite the shift lever position being N or R, the transmission control ECU sets the DTC.
For more details of the transmission shift main switch, refer to DTC P0820 (Click here).
DTC No.
DTC Detection Conditions
Trouble Areas
P0821
The transmission control ECU detects the following conditions simultaneously:
(1 trip detection logic)
  1. Shift lever position is in N or R
  2. MDSW signal is ON for 1.0 second
  1. Transmission shift main switch (built into shift lever assembly)
  2. Short in MDSW signal circuit
  3. Transmission control ECU

WIRING DIAGRAM

C110757E02

INSPECTION PROCEDURE


1. INSPECT TRANSMISSION SHIFT MAIN SWITCH
C112727E03
  1. Disconnect the shift lever assembly connector.

  1. Check the resistance when changing the shift lever position.

    Standard resistance:
    Tester Connections
    Shift Lever Position
    Specified Conditions
    MDSW (D81-4) - GND (D81-8)
    R, N or E
    10 kΩ or higher
    MDSW (D81-4) - GND (D81-8)
    M, + or -
    Below 1 Ω

  1. Reconnect the shift lever assembly connector.



NG
REPLACE TRANSMISSION SHIFT MAIN SWITCH
OK


2. CHECK HARNESS AND CONNECTOR (TRANSMISSION SHIFT MAIN SWITCH - TRANSMISSION CONTROL ECU)
C113923E04
  1. Disconnect the shift lever assembly connector.

  1. Disconnect the transmission control ECU connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connections
    Specified Conditions
    MDSW (D79-10) - MDSW (D81-4)
    Below 1 Ω
    MDSW (D79-10) - Body ground
    10 kΩ or higher

  1. Reconnect the shift lever assembly connector.

  1. Reconnect the transmission control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (TRANSMISSION SHIFT MAIN SWITCH - BODY GROUND)
C112728E03
  1. Disconnect the shift lever assembly connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connections
    Specified Conditions
    GND (D81-8) - Body ground
    Below 1 Ω

  1. Reconnect the shift lever assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSMISSION CONTROL ECU ASSEMBLY


← P0820 Gear Lever "X-Y" Position Sensor Circuit (from Nov 2005)P0885 TCM Power Relay Control Circuit (Open) (+ P0887) (from Nov 2005) →