P0821 Gear Lever "X" Position Circuit
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
Based on the signal from the transmission shift main switch, the transmission control ECU detects whether the shift lever position is in the E or M position. If the shift lever position switch is ON despite the shift lever position being N or R, the transmission control ECU sets the DTC.For more details of the transmission shift main switch, refer to DTC P0820 (Click here).
| DTC No. |
DTC Detection Conditions |
Trouble Areas |
| P0821 |
The transmission control ECU detects the following conditions simultaneously: (1 trip detection logic)
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT TRANSMISSION SHIFT MAIN SWITCH |
![]() ![]() |
Disconnect the shift lever assembly connector.
Check the resistance when changing the shift lever position.
- Standard resistance:
Tester Connections
Shift Lever Position
Specified Conditions
MDSW (D81-4) - GND (D81-8)
R, N or E
10 kΩ or higher
MDSW (D81-4) - GND (D81-8)
M, + or -
Below 1 Ω
Reconnect the shift lever assembly connector.
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TRANSMISSION SHIFT MAIN SWITCH - TRANSMISSION CONTROL ECU) |
![]() ![]() |
Disconnect the shift lever assembly connector.
Disconnect the transmission control ECU connector.
Check the resistance.
- Standard resistance:
Tester Connections
Specified Conditions
MDSW (D79-10) - MDSW (D81-4)
Below 1 Ω
MDSW (D79-10) - Body ground
10 kΩ or higher
Reconnect the shift lever assembly connector.
Reconnect the transmission control ECU connector.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (TRANSMISSION SHIFT MAIN SWITCH - BODY GROUND) |
![]() ![]() |
Disconnect the shift lever assembly connector.
Check the resistance.
- Standard resistance:
Tester Connections
Specified Conditions
GND (D81-8) - Body ground
Below 1 Ω
Reconnect the shift lever assembly connector.
|
|
||||
| OK | ||
| ||



