2005-2008 Yaris · Service Manual TRANSMISSION

P1875 Buzzer Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The buzzer inside the transmission control ECU sounds an alarm when the shift lever is moved into reverse or is mis-operated. This DTC is detected and output when power is not supplied to the buzzer built into the transmission control ECU.

HINT:
In addition, the buzzer sounds when one of the following conditions is met:
  1. When the transmission control ECU performs the shift rejection to prevent engine overrev.
  2. When the vehicle is stationary and the transmission control ECU operates the shift retry function.
  3. When the transmission control ECU judges the clutch overheat.

DTC No.
DTC Detection Conditions
Trouble Areas
P1875
The transmission control ECU detects the following conditions simultaneously:
(1 trip detection logic)
  1. The buzzer does not sound
  2. The buzzer operation voltage is 3 V or less for 5.0 seconds
  1. Transmission control ECU

INSPECTION PROCEDURE


1. CHECK BUZZER OPERATION
  1. Turn the ignition switch on (IG).

  1. Shift the shift lever into reverse.

  1. Check the buzzer operation.

    OK:
    The buzzer sounds.



NG
REPLACE TRANSMISSION CONTROL ECU ASSEMBLY
OK


2. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P1875)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Powertrain / Multi-Mode M/T / DTC.

  1. Read DTCs.

    Result:
    Display (DTC Output)
    Proceed To
    P1875
    A
    P1875 and other DTCs
    B

    If any DTCs other than P1875 are output, troubleshoot those DTCs first.



B
GO TO DTC CHART
A

REPLACE TRANSMISSION CONTROL ECU ASSEMBLY


← P0920 Gear Shift Forward Actuator Circuit (from Nov 2005)U0100 Lost Communication with ECM / PCM "A" (from Nov 2005) →