2005-2008 Yaris · Service Manual TRANSMISSION

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The transmission control ECU and ECM communicate with each other via the CAN communication line.
The transmission control ECU also communicates with the other computers through the ECM.
DTC No.
DTC Detection Conditions
Trouble Areas
U0100
No communication with the ECM
(1 trip detection logic)
  1. Open or short in CAN signal circuit
  2. ECM
  3. Transmission control ECU

WIRING DIAGRAM

C127411E01

INSPECTION PROCEDURE

HINT:
  1. Refer to inspection procedure for the CAN communication system (Click here).
  2. If the CAN communication malfunctions, the transmission control ECU cannot receive the current data from the ECM. In this case, the freeze frame data output from the transmission control ECU have not been updated so that it will not be useful information for the inspection procedure. However, reading the Data List as the first step of troubleshooting is effective to find malfunctions.
  3. The malfunction area can be checked using BUS CHECK on the intelligent tester function (Click here).
  4. For details of the 1ND-TV ECM terminals, refer to TERMINALS OF ECM (Click here).

NOTICE:
In the table below, the values listed under Normal Conditions are for reference only. Do not depend solely on these reference values when deciding whether a part is faulty or not.

To check the Data List, perform the following procedure using the intelligent tester.
  1. Warm up the engine.
  2. Turn the ignition switch off.
  3. Connect the intelligent tester to the DLC3.
  4. Turn the ignition switch on (IG) and turn the tester ON.
  5. Following the display on the tester, read the Data List.
Items
[Abbreviation]
Measurement Items: Display
Normal Conditions
Diagnostic Notes
Calculated Engine Load
[Calc E/G Load]
Calculated load by ECM:
Min.: 0 %, Max.: 100 %
10 to 25 %: Idling
5 to 20 %: Running without load (2,500 rpm)
-
Engine Coolant Temperature
[Coolant Temp]
Coolant temperature:
Min.: -40°C , Max.: 215°C
75 to 95°C (167 to 203°F):
After engine warmed up
  1. If value -40°C (-40°F): sensor circuit open
  2. If value 140°C (284°F): sensor circuit shorted
Backup Engine Speed
[Bacup Engin Spd]
Back-up engine speed:
Min.: 0 rpm, Max.: 8,160 rpm
0 rpm: Vehicle stopped
Approximately same as tachometer reading: Vehicle running
0 rpm displayed when malfunction in CAN communication
Accelerator Pedal Angle
[Accel Pedl Angl]
Accelerator pedal angle
Min.: 0 %, Max.: 100 %
0 %: Accelerator pedal released
0 % displayed when malfunction in CAN communication

NOTICE:
In ECM replacement, perform the REGISTRATION (Injector compensation codes) after installing the ECM (Click here).


← P1875 Buzzer Malfunction (from Nov 2005)Starter Signal Circuit (from Nov 2005) →