2005-2008 Yaris · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Jan 2006

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. INSTALL SIDE AIR BAG SENSOR
  1. Confirm that the ignition switch is turned to off.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. B106573E01
    Insert the hook into the body hole and install the airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. Do not use a side airbag sensor that has been dropped.
    2. Do not subject the side airbag sensor to any impact or force.

  1. Confirm that there is no looseness by shaking the side airbag sensor.

  1. B106574E01
    Connect the airbag connector.


2. INSTALL CENTER PILLAR LOWER GARNISH RH

  1. B134767
    Engage the 2 clips and 3 claws and install the center pillar lower garnish.


3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH

  1. B134773E01
    Align the location mark with the paint mark first, and install the rear door opening trim weatherstrip, as shown in the illustration.

    Paint mark:
    Area
    Color
    RH side
    Green
    LH side
    Red


4. INSTALL REAR DOOR SCUFF PLATE RH

  1. B134771
    Engage the 7 claws and install the rear door scuff plate.


5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

  1. B134766E01
    Align the location mark with the paint mark first, and install the front door opening trim weatherstrip, as shown in the illustration.

    Paint mark:
    Area
    Color
    RH side
    Blue
    LH side
    Pink


6. INSTALL FRONT DOOR SCUFF PLATE RH

  1. B134764
    Engage the 11 claws and install the front door scuff plate.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


8. INSPECT SRS WARNING LIGHT
(Click here)
← REMOVAL (from Jan 2006)COMPONENTS (from Aug 2005) →