REMOVAL
Removal / installation · Vehicles built from Jan 2006
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
- HINT:
- The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
| 1. REMOVE FRONT DOOR SCUFF PLATE RH |
Disengage the 11 claws and remove the front door scuff plate.

| 2. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
Remove the front door opening trim weatherstrip.

| 3. REMOVE REAR DOOR SCUFF PLATE RH |
Disengage the 7 claws and remove the rear door scuff plate.

| 4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
Remove the rear door opening trim weatherstrip.

| 5. REMOVE CENTER PILLAR LOWER GARNISH RH |
Disengage the 3 claws and 2 clips and remove the center pillar lower garnish.

| 6. REMOVE SIDE AIRBAG SENSOR |
- CAUTION:
- Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
Slide the outer housing and detach the airbag connector.

Remove the bolt, disengage the hook and remove the side airbag sensor.

