2005-2008 Yaris · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Nov 2006


1. REMOVE REAR BUMPER SIDE SEAL LH

  1. B160120
    Using a screwdriver, remove the 3 clips and the rear bumper side seal.


2. REMOVE REAR BUMPER SIDE SEAL RH

HINT:
Use the same procedure as for the LH side.


3. REMOVE NO. 1 FLOOR UNDER COVER

  1. B163735
    Using a screwdriver, remove the 5 clips and the No. 1 floor under cover.


4. REMOVE REAR BUMPER COVER

  1. B160122E01
    Apply protective tape as shown in the illustration.

  1. B160123
    Using a screwdriver, remove the clip.

  1. Remove the 2 bolts.

  1. B160124E01
    Insert a clip remover into the engaged portion between the rear bumper and rear bumper side retainer, 20 mm (0.787 in.) from the end of the rear bumper arch.

  1. Pull the rear bumper outward while pushing the rear bumper side retainer downward.

  1. B160125E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws.

  1. B160126
    Disengage the 4 claws and remove the rear bumper cover.

  1. B160128
    Remove the 4 clamps.

  1. Disconnect the 2 rear fog light connectors and the 2 license plate light connectors.


5. REMOVE REAR BUMPER SIDE RETAINER LH

  1. B114390
    Remove the screw.

  1. Using a clip remover, disengage the 2 claws and remove the rear bumper side retainer.


6. REMOVE REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.


7. REMOVE REAR BUMPER REINFORCEMENT

  1. B160129
    Remove the 6 bolts.

  1. Disengage the 2 hooks and remove the rear bumper reinforcement.


8. REMOVE NO. 2 REAR BUMPER REINFORCEMENT

  1. B163736
    Disengage the 2 hooks and remove the No. 2 rear bumper reinforcement.


9. REMOVE REAR FOG LIGHT ASSEMBLY LH

  1. B160131
    Remove the 2 nuts.

  1. Disengage the 2 claws and remove the rear fog light.


10. REMOVE REAR FOG LIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


11. REMOVE LICENSE PLATE LIGHT ASSEMBLY

B160132

HINT:
Use the same procedure for the opposite side.

  1. Disengage the 2 claws and remove the license plate light.

← COMPONENTS (from Nov 2006)INSTALLATION (from Nov 2006) →