2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

D005902E01
  1. Coat 2 new apply gaskets with ATF and install them into the transaxle case.

  1. D005901E01
    Install the check ball body spring and check ball body.

  1. C093940E11
    Align the groove of the manual valve with the pin of the manual valve lever.

  1. Provisionally install the valve body with the 13 bolts.

    Bolt length:
    Bolt A:
    32 mm (1.26 in.)
    Bolt B:
    22 mm (0.87 in.)
    Bolt C:
    55 mm (2.17 in.)
    Bolt D:
    45 mm (1.77 in.)

  1. C093939E08
    Provisionally install the detent spring and detent spring cover with the 2 bolts.

    Bolt length:
    Bolt A:
    14 mm (0.55 in.)
    Bolt B:
    45 mm (1.77 in.)

  1. Check that the manual valve lever comes into contact with the center of the roller at the tip of the detent spring.

  1. Tighten the 15 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. C093938E05
    Install the ATF temperature sensor with the lock plate and bolt.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Connect the 5 shift solenoid valve connectors.


2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

D005904E04
  1. Coat a new oil strainer gasket with ATF, and install it into the oil strainer.

  1. C062685E02
    Install the oil strainer with the 3 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }


3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

C093943E02
  1. Install the 2 magnets onto the oil pan, as shown in the illustration.

  1. D008009E01
    Install the oil pan and a new gasket with the 19 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:
T-WS

Capacity:
2.9 liters (3.1 US qts, 2.6 lmp. qts)


6. INSPECT AUTOMATIC TRANSAXLE FLUID

D025120E03

HINT:
Drive the vehicle until the engine and transaxle are at normal operating temperature.

Fluid temperature:
70 to 80 °C (158 to 176 °F)

  1. Park the vehicle on a level surface and engage the parking brake.

  1. With the engine idling and the brake pedal depressed, shift the shift lever into all positions from P to L, and then return it to the P position.

  1. Pull out the oil level gauge and wipe it clean.

  1. Push it fully back into the pipe.

  1. Pull it out and check that the fluid level is within the HOT range.
    If there is any leakage, repair or replace O-rings, FIPGs, oil seals, plugs or other parts.


7. CHECK AUTOMATIC TRANSAXLE FLUID LEAKAGE

8. INSTALL ENGINE UNDER COVER LH
← REMOVAL (from Aug 2005)ON-VEHICLE INSPECTION (from Aug 2005) →