2005-2008 Yaris · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ENGINE UNDER COVER LH

3. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

C062684E01
  1. Remove the 19 bolts and remove the oil pan and oil pan gasket.

    NOTICE:
    Some fluid will remain in the oil pan.
    Remove all the oil pan bolts, and carefully remove the oil pan sub-assembly.

  1. C093943E04
    Remove the 2 magnets from the oil pan.

  1. AT00103E01
    Examine the particles in the pan.

    1. Collect any steel chips using the removed magnets.
      Carefully inspect the foreign matter and particles in the pan and on the magnets to guess at the type of wear which might be found in the transaxle.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bearing wear


5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

C062685E02
  1. Remove the 3 bolts and remove the oil strainer.

    NOTICE:
    Perform the operation carefully as some fluid will come out from the oil strainer.

  1. D005904E04
    Remove the oil strainer gasket from the oil strainer.


6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY

C093938E05
  1. Disconnect the 5 connectors.

  1. Remove the bolt and lock plate and remove the ATF temperature sensor.

  1. C093939E07
    Remove the 2 bolts and remove the detent spring cover and detent spring.

  1. C093940E10
    Remove the 13 bolts and remove the valve body assembly.

    NOTICE:
    Do not drop the check ball body, check ball body spring or accumulator piston.

  1. D005901E01
    Remove the check ball body and check ball body spring.

  1. D005902E01
    Remove the 2 apply gaskets.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →