2005-2008 Yaris · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT REVERSE CLUTCH DISC

C067868
  1. Check whether the sliding surfaces of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all the discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.


INSPECT DIRECT CLUTCH DISC

C067870
  1. Check whether the sliding surface of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all the discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.


INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY

C067872
  1. Using vernier calipers, measure the free length of the spring together with the spring seat.

    Standard free length:
    32.9 mm (1.2953 in.)


INSPECT DIRECT CLUTCH PISTON SUB-ASSEMBLY

C068212
  1. Shake the direct clutch pin and confirm that the check ball is not stuck.

  1. Apply low pressure compressed air to the check ball and check that no air leakage is identified.


INSPECT INTERMEDIATE SHAFT SUB-ASSEMBLY

C068213
  1. Shake the direct clutch pin and confirm that the check ball is not stuck.

  1. Apply low pressure compressed air to the check ball and check that no air leakage is identified.

← DISASSEMBLY (from Aug 2005)REASSEMBLY (from Aug 2005) →