2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Always use "Torx" socket wrench E10 when removing the rear seat.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Luggage Compartment Room Light)

2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

  1. B114569E01
    Remove the 2 package tray trim suspenders.

  1. Remove the 5 pieces of hook tape.

  1. Disengage the 2 claws and remove the package tray trim.


3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

  1. B106371
    Release the 2 knobs and remove the deck board.


4. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)

  1. B119913
    Remove the spare wheel cover.


5. REMOVE DECK FLOOR BOX RH (w/ Deck Board)

  1. B106372
    Release the 2 knobs and remove the deck floor box.


6. REMOVE DECK FLOOR BOX LH (w/ Deck Board)

HINT:
Use the same procedure as for the RH side.


7. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)

  1. B119912
    Remove the rear floor carpet.


8. REMOVE NO. 1 REAR SEAT LEG COVER
  1. for RH Side:

    1. Remove the No. 1 rear seat leg cover (Click here).

  1. for LH Side:

    1. Remove the No. 1 rear seat leg cover (Click here).


9. REMOVE NO. 2 REAR SEAT LEG COVER

  1. B126921E01
    Disengage the 3 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.


10. REMOVE REAR SEAT ASSEMBLY RH

  1. B114660
    Using "Torx" socket wrench E10, remove the 2 bolts and pull up the rear seat cushion.

  1. B119885
    Using "Torx" socket wrench E10, remove the 4 bolts and the rear seat.


11. REMOVE REAR SEAT ASSEMBLY LH

  1. B114740
    Using "Torx" socket wrench E10, remove the 3 bolts and pull up the rear seat cushion.

  1. B117760
    Using "Torx" socket wrench E10, remove the 4 bolts and the rear seat.


12. REMOVE REAR DOOR SCUFF PLATE RH

  1. B114287
    Disengage the 6 claws and remove the rear door scuff plate.


13. REMOVE REAR DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side.


14. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

  1. B114431
    Remove the rear door opening trim weatherstrip to the extent that the deck trim side panel and roof side inner garnish can be removed.


15. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure as for the RH side.


16. REMOVE REAR DECK TRIM COVER

  1. B117692
    for Temper Spare Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.

  1. B114283
    for Grand Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.


17. REMOVE REAR SEAT OUTER BELT ASSEMBLY RH

  1. B114289
    Remove the belt.

  1. B130498
    Remove the bolt.

  1. Disengage the clip and remove the anchor plate.


18. REMOVE REAR SEAT OUTER BELT ASSEMBLY LH

HINT:
Use the same procedure as for the RH side.


19. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH

  1. B114573
    w/ Package Tray Trim:

    1. Remove the 3 screws.

    2. Disengage the 3 clips and the 6 claws and remove the deck trim side panel.

  1. B114290
    w/o Package Tray Trim:

    1. Remove the 3 screws.

    2. Disengage the 4 clips and the 6 claws and remove the deck trim side panel.


20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

  1. B114574
    w/ Package Tray Trim:

    1. w/ Luggage Compartment Room Light:

      1. Remove the 3 screws.
      2. Disengage the 3 clips and the 6 claws.
      3. Disconnect the luggage compartment room light connector and remove the deck trim side panel.

    2. w/o Luggage Compartment Room Light:

      1. Remove the 3 screws.
      2. Disengage the 3 clips and the 6 claws and remove the deck trim side panel.

  1. B114291
    w/o Package Tray Trim:

    1. w/ Luggage Compartment Room Light:

      1. Remove the 2 screws.
      2. Disengage the 4 clips and the 6 claws.
      3. Disconnect the luggage compartment room light connector and remove the deck trim side panel.

    2. w/o Luggage Compartment Room Light:

      1. Remove the 2 screws.
      2. Disengage the 4 clips and the 6 claws and remove the deck trim side panel.


21. REMOVE ROOF SIDE INNER GARNISH RH

  1. B114462E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the center belt guide.

  1. B114576E01
    w/ Curtain Shield Airbag:

    NOTICE:
    Replace the special clip with a new one when the roof side inner garnish is removed.


    1. Disengage the 5 clips.

    2. Pass the rear seat outer belt and the rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

  1. B114575
    w/o Curtain Shield Airbag:

    1. Disengage the 5 clips.

    2. Pass the rear seat outer belt and the rear center seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.


22. REMOVE ROOF SIDE INNER GARNISH LH

  1. B114578E01
    w/ Curtain Shield Airbag:

    NOTICE:
    Replace the special clip with a new one when the roof side inner garnish is removed.


    1. Disengage the 5 clips.

    2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.

  1. B114577
    w/o Curtain Shield Airbag:

    1. Disengage the 5 clips.

    2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.


23. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY

  1. B114459
    Remove the 2 tongue plates.

  1. B114460E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and open the slip joint cover.

  1. B114461
    Remove the bolt and the through anchor.

  1. B114463
    Remove the bolt, the hook and the bracket.

  1. B114551
    Remove the bolt, the 2 hooks and the retractor.


24. REMOVE SEAT BELT ANCHOR COVER

  1. B114464
    Using a moulding remover, disengage the 4 claws and remove the seat belt anchor cover.


25. REMOVE ROOF HEADLINING ASSEMBLY

  1. B114465
    Using a clip remover, remove the clip and the roof headlining.


26. REMOVE REAR SEAT SHOULDER BELT COVER

  1. B114466
    Disengage the 2 claws and remove the rear seat shoulder belt cover.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →