2005-2008 Yaris · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the driver side for LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).


2. REMOVE FRONT SEAT HEADREST ASSEMBLY

  1. B138677E01
    Push in the lock button of the front seat headrest support and remove the front seat headrest.


3. REMOVE FRONT SEAT UNDER TRAY (w/ Under Tray)

  1. B119870
    Remove the front seat under tray.


4. REMOVE FRONT SEAT ASSEMBLY

  1. B119871E01
    Disconnect the buckle switch connector.

  1. w/ Front Seat Side Airbag:

    1. Disconnect the airbag connector.

      1. Slide the slider and disconnect the airbag connector.

  1. B119872
    Using "Torx" socket wrench E10, remove the 4 bolts and front seat.

← COMPONENTS (from Aug 2005)DISASSEMBLY (from Aug 2005) →